Installation Instructions

3
JED Tag
2. Hold the tag so that the printed text or image is right side up and facing toward you ( Figure 3). Press
the tag against the windshield and hold for 10 seconds.
Note: When installing the tag using the mounting strips for the first time, leave the tag in
place for at least 24 hours to allow the adhesive to cure.
Suction cups
1. Hold the tag so that the printed text or image is right side up and facing toward you (Figure 3).
2. Moisten the cups and stick the tag to the windshield.
3. Press the tag against the windshield and hold for 10 seconds.
Removing the Tag
To remove a tag installed with mounting strips from the windshield, grip the tag at the top and bottom
sides. Gently lift the tag away from the windshield on one end until the tag is free from the windshield.
To remove a tag installed with suction cups, slide a finger under the tab on the suction cup to loosen it
from the windshield surface.
TA0444-002
Figure 3 Correct Tag Orientation