Installation Instructions

Page 3
GoAnywhere Pass
GoAnywhere Pass Installation and Removal
Required Supplies
• GoAnywhere Pass
• Optional mounting bracket (sold separately)
• Commercial glass cleaner and paper towels
Installation with Dual Lock Strips
1. Choose the location for your tag. The tag should be mounted approximately 1 inch (2.54 cm) below the
rearview mirror post (Figure 3).
2. Clean and dry the interior windshield surface completely before axing the Dual Lock strips. The
windshield temperature must be at least 68ºF (20ºC) for optimum bonding.
3. Peel the backing o the Dual Lock strips to expose adhesive (Figure 4). Leave both sides of the Dual Lock
strips pressed together to ensure the strips will align between the GoAnywhere Pass and windshield.
Apply the GoAnywhere Pass to the windshield using moderate pressure.
Note: When installing the GoAnywhere Pass using Dual Lock strips for the first time, leave it in place
for at least 24 hours to allow the adhesive to cure.
Figure 3 – Preferred mounting locations for best tag performance
Figure 4 – Remove backing from Dual Lock strips