Installation Instructions

Page 5
GoAnywhere Pass
4. To remove the tag from the bracket, hold the bracket in both hands. Hold the two upper tabs with your
fingers, and at the same time, push the tag up through the opening on the bottom part of the bracket. The
tag should slide out of the bracket (Figure 7).
5. To remove the bracket from the windshield, locate the tab on each suction cup (Figure 8). Hold the bracket
with one hand and use your other hand to slide a finger underneath the tab and gently pull up. The suction
cup should release from the mounting surface. Repeat the process with the opposite side.
GoAnywhere Pass Battery Replacement
If your tag is equipped with a permanent battery, skip this section and go to “Audio/Visual Signals”
on page 7. If your tag has replaceable batteries, continue to Step 1.
1. Two lithium AAA batteries are pre-installed in your GoAnywhere Pass. To replace the batteries, remove the
GoAnywhere Pass from the windshield as described in “GoAnywhere Pass Installation and Removal” on
page 3.
Figure 7 – Remove tag from bracket
Figure 8 – Locate tab on suction cup