Installation Instructions

NOTE: For proper operation, the GoAnywhere Pass requires lithium batteries. TransCore

recommends Energizer® Advanced Lithium AAA batteries.

2. Hold the GoAnywhere Pass with the LED side facing down. Locate the battery door. Press the indentation

located under the arrow and slide the door in the direction of the arrow to open the door.

3. Remove the old batteries and replace them with lithium AAA batteries according to the diagram on the

inside of the battery compartment (Figure 9).

4. Close the cover and slide it back into place. You should hear a soft snap when the cover is in the correct

position.

5. Immediately after fresh batteries are installed, a brief audio/visual sequence will occur as the GoAnywhere

Pass powers up. Refer to the Ready to Go section in Table 1 for a description of the audio/visual signals. If

there is an ASTM V6 AV code stored, the sequence may take up to 15 minutes to complete.

6. Reinstall the GoAnywhere Pass on the windshield by pressing it back onto the Dual Lock strips or sliding it

back into the mounting bracket.

Figure 9 – Replaceable batteries