Installation Instructions

TransCore Proprietary

Connecting Power Harness to Vehicle Fuse Panel

Note: Refer to Figure 1 for a diagram of the terms shown in bold text.

1. Locate the black and red wire pair on the power harness. Trim wire length as required. Crimp

one of the supplied quick disconnects onto the red wire. Ensure that the crimped connection

is secure (Figure 2).

2. Crimp one of the supplied ring terminals onto the black wire (Figure 3). Ensure the crimped

connection is secure.

3. Attach the ring terminal to a ground point on the vehicle such as a bolt or nut that is attached

to bare metal.

Figure 2 – Crimp Quick Disconnect onto Red Wire

Figure 3 – Crimp Ring Terminal onto Black Wire