User's Manual

WARNING TO USERS IN THE UNITED STATES FEDERAL
COMMUNICATIONS COMMISSION (FCC) LOCATION AND
MONITORING SERVICE STATEMENT
47 CFR §90.351
Get Digital I/O Output Host Control
This command gets the digital I/O outputs that the host controls.
Table 11 and Table 12 list the command and response data.
Table 11.
Get Digital I/O Output Host Control Command (0003H)
NOTE: The user is required to obtain a Part 90 site license from the FCC
to operate this radio frequency identification (RFID) device in the United
States. See product label for FCC ID number. Access the FCC Web site
at www.fcc.gov/Forms/Form601/601.html for additional information
concerning licensing requirements.
Get Digital I/O Output Host Control Data Data Payload
Get Digital I/O Output Host Control Command 0003H
Table 12. Get Digital I/O Output Host Control Response
NOTE: Users in all countries should check with the appropriate local
authorities for licensing requirements.
Get Digital I/O Output Host Response Data Data Payload
Get Digital I/O Output Host Control Command 0003H
Output Control 0XH
FCC RADIO FREQUENCY INTERFERENCE STATEMENT
47 CFR §15.105(a)
NOTE: This equipment has been tested and found to comply with the
limits for a Class A digital device pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate RF
energy and may cause harmful interference to radio communications if
not installed and used in accordance with the instruction manual.
Operating this equipment in a residential area is likely to cause harmful
interference, in which case, depending on the regulations in effect, the
user may be required to correct the interference at their own expense.
Output Control — This field specifies the digital outputs that the
host controls. In Table 13, OFF = 0 and ON = 1.
Table 13. Output Control Values
Control
Value
Output
Control 3
Output
Control 2
Output
Control 1
Output
Control 0
00H OFF OFF OFF OFF
01H OFF OFF OFF ON
02H OFF OFF ON OFF
03H OFF OFF ON ON
NO UNAUTHORIZED MODIFICATIONS
47 CFR §15.21
CAUTION: This equipment may not be modified, altered, or changed in
any way without permission from TransCore, LP. Unauthorized
modification may void the equipment authorization from the FCC and will
void the TransCore warranty.
USE OF SHIELDED CABLES IS REQUIRED
47 CFR §15.27(a)
NOTE: Shielded cables must be used with this equipment to comply with
FCC regulations.
TransCore, LP USA
13
4