User's Manual

Table 3. Set Digital I/O Port Configuration Response
Table of Contents
Set Digital I/O Port Configuration Response
Data
Data Payload
Set Digital I/O Port Configuration Command 0010H
Before Getting Started .................................................................. 7
Encompass Multiprotocol Reader Setup....................................... 7
Installing the Reader Module and Reader Multiplexer ............. 7
Port Configuration — This field specifies the digital port
input/output configuration.
In Table 4, IN = 0 and OUT = 1.
Installing the Antenna Multiplexer............................................. 9
Operating the EPCglobal Reader Module and Multiplexer
Options........................................................................................ 10
Table 4. Digital I/O Port Configuration Values
Configuration
Value
Digital
Port 3
Digital
Port 2
Digital
Port 1
Digital
Port 0
0FH OUT OUT OUT OUT
Set Digital I/O Port Configuration ........................................... 10
Get Digital I/O Port Configuration........................................... 11
Set Digital I/O Output Host Control......................................... 12
Get Digital I/O Output Host Control ........................................ 13
Note: RESET READER command required for changes to take effect. Be
sure to reset the reader before sending a Get Digital I/O Port
Configuration command.
List of Figures
Get Digital I/O Port Configuration
This command gets the digital I/O port configuration settings.
Table 5 and Table 6 list the command and response data.
Figure 1. Encompass Multiprotocol Reader Showing EPCglobal
Reader Module and Reader and Antenna Multiplexers................ 8
Figure 2. EPC Module-to-Encompass Reader Wiring Diagram.... 8
Table 5. Get Digital I/O Port Configuration Command (0011H)
Figure 3. Antenna Multiplexer-to-Digital I/O Wiring Diagram........ 9
Get Digital I/O Port Configuration Response
Data
Data Payload
Get Digital I/O Port Configuration Command 0011H
List of Tables
Table 1. Antenna Multiplexer-to-Encompass Reader I/O Block ... 9
Table 6. Get Digital I/O Port Configuration Response
Table 2. Set Digital I/O Port Configuration Command (0010H).. 10
Get Digital I/O Port Configuration Command
Data
Data Payload
Get Digital I/O Port Configuration Command 0011H
Port Configuration 0FH
Table 3. Set Digital I/O Port Configuration Response ................ 11
Table 4. Digital I/O Port Configuration Values............................ 11
Table 5. Get Digital I/O Port Configuration Command (0011H).. 11
Table 6. Get Digital I/O Port Configuration Response................ 11
Table 7. Digital I/O Port Configuration Values............................ 12
Table 8.
Set Digital I/O Output Host Control Command (0002H) ........ 12
Table 9. Set Digital I/O Output Host Control Response.............. 12
Port Configuration — This field specifies the digital port
input/output configuration.
In Table 7, IN = 0 and OUT = 1.
Table 10. Output Control Values................................................. 12
Table 11.
Get Digital I/O Output Host Control Command (0003H) ...... 13
Table 12. Get Digital I/O Output Host Control Response ........... 13
Table 13. Output Control Values................................................. 13
6 11