User's Manual

36 CMU056-A1 www.RoperMobile.com
Return To Table of Contents
Making your own Power Supply Lead
To make your own power supply lead, you may order the power connector at Roper Mobile Technology using
the following information:
Roper Mobile Technology item #: NAM036
Manufacturer’s name and item #: SwitchCraft 760K
Note:
Be sure to insert a 3 amp time-lag fuse, or if you are using a fuse box, ensure to use a similar fuse.
All contacts must be clean and corrosion-free to avoid electrical resistance.
Keep the length of the Lead to a minimum.
Wiring
The Vehicle Cradle can have up to 3 serial cables connected at the same time.
The DU-C-0040 measures approximately 180 cm (70 in) and includes 2 DB-9
sockets. Its sole use if for communicating with the host computer via ActiveSync.
Note: Another type of cable may be required to link certain devices such as a GPS or external radio. The
DU-C-0040 may not be the appropriate cable for these devices and a special cable might therefore be required.
To customize your own cable, refer to the “Serial Connector Pin Layout” section for further information.
Installing Vehicle Mount
The vehicle cradle is compatible with the RAM-MOUNT System.
Roper Mobile Technology item #: DC813
RAM-MOUNT item number: RAM-B-101U
RAM-MOUNT offers several installation possibilities. For further information, consult their web site at
www.ram-mount.com.
The DC813 hinged support is comprised of the following parts:
1 RAM-B-201 Socket Arm with Handle
2 RAM-B-202 anti-vibration balls
3 screws
•
•
•
•
•
•
•
1.
2.
3.
USING VEHICLE CRADLE (CONTINUED)
Operation Guide
DU-C-0040