User's Manual

www.RoperMobile.com CMU056-A1 43
Return To Table of Contents
BARCODE READERS
Laser Scanner
The ‘Laser Scanner’ function will depend on the
application used and a special software driver.
Refer to your application’s User Guide for further
instructions. Information included are basic
scanning instructions.
Refer to the diagram to the right for right and wrong
scanning methods.
Testing the Scanner
To test the scanner, click on:
a) Start
b) Programs
c) DAP Utilities
d) CE Pad
To activate scanner point the top of the unit
toward the barcode label needed to be scanned.
Press the ‘trigger’ button located on the side
of the unit and move the unit back and forth
so the beam completely crosses the label.
Once the label has been decoded, the unit will
sound a short ‘beep’.
Note: If you keep the ‘trigger’ button pressed for
too long, the unit will stop scanning by itself after a
few moments. The unit will sound two (2) beeps to
indicate that no barcode has been detected.
Advanced Users: Refer to the CE3000B Technical
Guide for further instructions on programming.
CAUTION
Avoid Exposure to Laser Light Beam.
Do not intentionally look into the Laser Light
Beam.
1.
2.
3.
4.
•
•
Right
Wrong
Adaptable Endcap Options
Trigger Button