User's Manual

30 CMU056-A1 www.RoperMobile.com
Return To Table of Contents
Operation Guide
USING PC & SDIO CARDS (CONTINUED)
WARNING
Installing PC cards is not recommended
when Adaptable Endcap is installed.
Insert PC or SDIO Cards in a clean
and dry environment to ensure no
dust particles or water enters the unit.
Ensure to insert PC or SDIO Cards
appropriately or you may damage the unit.
a) PC Cards: Insert the end with the
two (2) rows of little holes rst and
manufacturer label facing upwards.
b) SDIO Cards: Insert the end with the row
of copper ngers rst and manufacturer label
facing upwards.
Removing PC or SDIO Cards
Turn the unit off.
Using a Flathead screwdriver, loosen the 2
screws located at the top of your unit on Endcap.
Remove the Endcap slowly and place to the side.
Note: The screws will remain inside the Endcap.
a) To remove the PC Card from the
unit, press the ‘release button’ lo-
cated to the right of the PC Card opening.
b) To remove the SDIO Card, push gen-
tly once and card will pop up. Remove card.
Replace the door to its original position and
tighten screws.
1.
2.
3.
1.
2.
3.
4.