User's Manual

Rugged Tablet PC
7

RF exposure information (SAR)
This Rugged Table PC meets the government's requirements for exposure to radio waves.
This
Rugged Table PC is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications Commission
of the U.S. Government. The exposure standard for wireless
Rugged Table PC employs a
unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by
the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions
accepted by the FCC with the
Rugged Table PC transmitting at its highest certified power
level in all tested frequency bands. Although the SAR is determined at the highest certified
power level, the actual SAR level of the
Rugged Table PC while operating can be well below
the maximum value. This is because the
Rugged Table PC is designed to operate at multiple
power levels so as to use only the poser required to reach the network. In general, the
closer you are to a wireless base station antenna, the lower the power output. The highest
SAR value for US model
Rugged Table PC as reported to the FCC when tested for use at
the body, as described in this user guide, is 0.770 W/kg.
Industry Canada Class B Statement
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada licence-exempt RSS standard(s).Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
IEEE 802.11b or 802.11g operation of this product in the Canada is firmware-limited to
channels 1 through 11.
Déclarations d'exposition aux RF liéesAvertissement d'exposition RF: L'équipement est
conforme aux limites d'exposition aux RF établies pour un environnement non contrôlé.
L'antenne (s) utilisée pour ce transmetteur ne doit pas être co-localisés ou fonctionnant en
conjonction avec une autre antenne ou transmetteur.
Ce dispositif est conforme à la norme de l'industrie Candada exempts de licence RSS (s).
L'opération est soumise aux deux conditions suivantes: (1) Cet appareil ne peut causer
d'interférences nuisibles, et (2) cet appareil doit accepter toute interférence reçue, y
compris les interférences qui peuvent causer un mauvais fonctionnement de l'appareil.