Users Manual Part 4

Table 57 Encompass 4 Reader Commands Listed Alphabetically
Command Name Number Reader Message
Enable IAG 487
Done if tag protocol
supported/Error if tag
protocol is unsupported
Enable input inversion 6941 Done
Enable multi-tag sort 454 Done
Enable presence without tag reports 6901 Done
Enable Retransmit 845
Enable second alternate group select 459 Done
Enable SeGo 485
Done if tag protocol
supported/Error if tag
protocol is unsupported
Enable software flow control (default) 6141 Done
Enable tag translation mode 453 Done
Enable third alternate group select 491 Done
Enable Wiegand mode 451 Done
Load default operating parameters 66F Done
No auxiliary information appended (default) 310 Done
No time and date appended 300 Done
Output pulse duration set to 228 ms (default) 67C Done
Report buered handshakes 577
XX = number of
handshakes
Report change on input0 821 Done
Report change on input1 822 Done
Report changes on input0 and input1 823 Done
Reset power fail bit 65 Done
Reset reader 63
Model E4 Series Ver
X.XX SNSSSSSS
Reset uniqueness 440 Done
RF Control 640N Done
Select 1 valid ID code (default) 4200 Done
Appendix D Command Quick Reference
TransCore Proprietary
D–13

Summary of content (10 pages)