User's Manual
Table Of Contents
- Contents
- Before You Begin
- Developing the Installation Site Plan
- Installing and Configuring the MPI 6000
- Lane Tuning Guidelines
- Optimizing MPI 6000 Reader System Performance
- General Software Information
- Configuration Commands and Responses
- Configuring the MPI 6000
- Required Commands to Set Up MPI 6000 Reader
- System Interface Command Group Commands
- System Identify
- Set Communications Baud Rate
- Get Communications Baud Rate
- Set Time and Date
- Get Time and Date
- Firmware Download
- Reset Reader
- Get Stored Tag Response Message
- Get Number of Stored Tag Response Messages
- Delete All Stored Tag Response Messages
- Get System Startup Status
- Get Lane Controller Interface Status
- Get System Interface Status
- Get DigBrd Hdwr Remote Inventory
- Get DigBrd CPU Boot Fmwr Remote Inventory
- Get DigBrd CPU Appl Fmwr Remote Inventory
- Get DigBrd FPGA UDP/IP Core Fmwr Remote Inventory
- Get UDP/IP Core Lane Controller Parameters
- Set UDP/IP Core IP Address
- Get UDP/IP Core IP Address
- Get UDP/IP Core Port Number
- Configuring the MPI 6000
- Tag Command Processing
- System Diagnostics and Preventive Maintenance
- Acronyms and Glossary
- Block Diagrams
- System Technical Specifications
- Hardware Interfaces
Acronyms and Glossary
A-5
I
I/O input/output
IAG Inter-Agency Group, distributor of IAG tags
ID identification; encoded information unique to a particular tag
in inch(es)
interfa
ce connection point for communicatio
ns with another device
IRQ interrupt
request
J
JP jumper pin
K
k kilo (10
3
)
kg kilogram(s)
L
lane controller device that is used to integrate all activity that occurs in a toll lane.
lb pound(s)
LED light-emitting diode
M
message combination of fields, frames, and pages as required by the system to transmit or
receive associated command and response data to and from the reader and host com-
puter
m meter(s)
mA milliamp(s)
Mega million (10
6
)
MB megabyte(s)
MHz megahertz
PRELIMINARY