User's Manual
Table Of Contents
- Contents
- Before You Begin
- Developing the Installation Site Plan
- Installing and Configuring the MPI 6000
- Lane Tuning Guidelines
- Optimizing MPI 6000 Reader System Performance
- General Software Information
- Configuration Commands and Responses
- Configuring the MPI 6000
- Required Commands to Set Up MPI 6000 Reader
- System Interface Command Group Commands
- System Identify
- Set Communications Baud Rate
- Get Communications Baud Rate
- Set Time and Date
- Get Time and Date
- Firmware Download
- Reset Reader
- Get Stored Tag Response Message
- Get Number of Stored Tag Response Messages
- Delete All Stored Tag Response Messages
- Get System Startup Status
- Get Lane Controller Interface Status
- Get System Interface Status
- Get DigBrd Hdwr Remote Inventory
- Get DigBrd CPU Boot Fmwr Remote Inventory
- Get DigBrd CPU Appl Fmwr Remote Inventory
- Get DigBrd FPGA UDP/IP Core Fmwr Remote Inventory
- Get UDP/IP Core Lane Controller Parameters
- Set UDP/IP Core IP Address
- Get UDP/IP Core IP Address
- Get UDP/IP Core Port Number
- Configuring the MPI 6000
- Tag Command Processing
- System Diagnostics and Preventive Maintenance
- Acronyms and Glossary
- Block Diagrams
- System Technical Specifications
- Hardware Interfaces
Acronyms and Glossary
A-7
S
s second(s)
SeGo SeGo is a superset of the TransCore eGo protocol.
SRAM static random access memory
som start of message
system a reader, RF module, antenna, and tag, which are des
cribed by the genera
l application
and interfaces with each other and any connected devices that are defined as being
outside the system.
T
tag small, self-contained device acting as an identifying transponder
TDM time-division multiplexing, used in this document to refer to the use of time-division
multiplexing of multiple readers in proximity
of each other.
Title 21 state of California code of regulations, Chapter 16, T
itle 21, which is the standard used
for AVI/DSRC (digital
short-range communications) protocol
toll any application of the system equipment wherein the equipment is used to assist in the
orderly collec
tion of money in exchange for the passage of a vehicle through a partic-
ular installation point
TrAC TransCore Action Center
transponder a tag
U
UART universal asynchronous receiver-transmitter
UTA universal toll antenna
V
V volt(s)
VCC voltage controlled current
Ver version (software)
PRELIMINARY