User's Manual
Table Of Contents
- Contents
- Before You Begin
- Developing the Installation Site Plan
- Installing and Configuring the MPI 6000
- Lane Tuning Guidelines
- Optimizing MPI 6000 Reader System Performance
- General Software Information
- Configuration Commands and Responses
- Configuring the MPI 6000
- Required Commands to Set Up MPI 6000 Reader
- System Interface Command Group Commands
- System Identify
- Set Communications Baud Rate
- Get Communications Baud Rate
- Set Time and Date
- Get Time and Date
- Firmware Download
- Reset Reader
- Get Stored Tag Response Message
- Get Number of Stored Tag Response Messages
- Delete All Stored Tag Response Messages
- Get System Startup Status
- Get Lane Controller Interface Status
- Get System Interface Status
- Get DigBrd Hdwr Remote Inventory
- Get DigBrd CPU Boot Fmwr Remote Inventory
- Get DigBrd CPU Appl Fmwr Remote Inventory
- Get DigBrd FPGA UDP/IP Core Fmwr Remote Inventory
- Get UDP/IP Core Lane Controller Parameters
- Set UDP/IP Core IP Address
- Get UDP/IP Core IP Address
- Get UDP/IP Core Port Number
- Configuring the MPI 6000
- Tag Command Processing
- System Diagnostics and Preventive Maintenance
- Acronyms and Glossary
- Block Diagrams
- System Technical Specifications
- Hardware Interfaces
Hardware Interfaces
D-5
Table D-3 RS-232B/TDM Connector Parameters
Pin Signal Description
1 TXD Transmit Data
2 RXD Receive Data
3 DTR Data Terminal Ready (not connected)
4 RTS Request to Send
5 CTS Clear to Send
6 GND Ground
7 TDM + TDM positive signal
8 TDM - TDM negative signal
Table D-4 RS-232 Diagnostics Connector Parameters
Pin Signal Description
1 5V PWR 5V power supply for I/O board
2 GND GND
3 I/O Signal 1
4 I/O Signal 2
5 I/O Signal 3
6 I/O Signal 4
7 Tag in Field 1 Contact Closure 1 for Tag in Field Signal
8 Tag in Field 2 Contact Closure 2 for Tag in Field Signal
PRELIMINARY