User's Manual
Table Of Contents
- Contents
- Before You Begin
- Developing the Installation Site Plan
- Installing and Configuring the MPI 6000
- Lane Tuning Guidelines
- Optimizing MPI 6000 Reader System Performance
- General Software Information
- Configuration Commands and Responses
- Configuring the MPI 6000
- Required Commands to Set Up MPI 6000 Reader
- System Interface Command Group Commands
- System Identify
- Set Communications Baud Rate
- Get Communications Baud Rate
- Set Time and Date
- Get Time and Date
- Firmware Download
- Reset Reader
- Get Stored Tag Response Message
- Get Number of Stored Tag Response Messages
- Delete All Stored Tag Response Messages
- Get System Startup Status
- Get Lane Controller Interface Status
- Get System Interface Status
- Get DigBrd Hdwr Remote Inventory
- Get DigBrd CPU Boot Fmwr Remote Inventory
- Get DigBrd CPU Appl Fmwr Remote Inventory
- Get DigBrd FPGA UDP/IP Core Fmwr Remote Inventory
- Get UDP/IP Core Lane Controller Parameters
- Set UDP/IP Core IP Address
- Get UDP/IP Core IP Address
- Get UDP/IP Core Port Number
- Configuring the MPI 6000
- Tag Command Processing
- System Diagnostics and Preventive Maintenance
- Acronyms and Glossary
- Block Diagrams
- System Technical Specifications
- Hardware Interfaces
MPI 6000 Multi-Protocol Reader System Guide
6-4
host PC is set to Dynamic TransCore recommends that you se
t the IP address to Static.
Table 6-1 lists the connector pin assignments.
Communications RS–232
The connector is an industry standard DB-9M plug. Table 6-2 lists this connector pin
assignments.
The RS-232B/Time-division multiplexing (TDM) connector
is an 8-pin terminal
block header. The
TDM signals must be isolated. Table 6-3 lists this connector pin
assignments.
Table 6-1 Ethernet Connector
Pin Signal Description
1 TPTX+ Output Differential Transmit Data +
2 TPTX- Output Differential Transmit Data -
3 TPRX+ Input Diff
erential Rece
ive Data +
4 NOT CONNECTED N/A
5 NOT CONNECTED N/A
6 TPRX- Input Differential Receive Data -
7 NOT CONNECTED N/A
8 NOT CONNECTED N/A
Table 6-2 Communications RS-232 Connector Parameters
Pin Signal Description
1 RSD Received line signal detect (not connected)
2 RXD Receive Data
3 TXD Transmit Data
4 DTR Data Terminal Ready (not connected)
5 GND Ground
6 DSR Data Set Ready (not connected)
7 RTS Request to Send
8 CTS Clear to Send
9 RI Ring indicator (not connected)
PRELIMINARY