User's Manual
Table Of Contents
- Contents
- Before You Begin
- Developing the Installation Site Plan
- Installing and Configuring the MPI 6000
- Lane Tuning Guidelines
- Optimizing MPI 6000 Reader System Performance
- General Software Information
- Configuration Commands and Responses
- Configuring the MPI 6000
- Required Commands to Set Up MPI 6000 Reader
- System Interface Command Group Commands
- System Identify
- Set Communications Baud Rate
- Get Communications Baud Rate
- Set Time and Date
- Get Time and Date
- Firmware Download
- Reset Reader
- Get Stored Tag Response Message
- Get Number of Stored Tag Response Messages
- Delete All Stored Tag Response Messages
- Get System Startup Status
- Get Lane Controller Interface Status
- Get System Interface Status
- Get DigBrd Hdwr Remote Inventory
- Get DigBrd CPU Boot Fmwr Remote Inventory
- Get DigBrd CPU Appl Fmwr Remote Inventory
- Get DigBrd FPGA UDP/IP Core Fmwr Remote Inventory
- Get UDP/IP Core Lane Controller Parameters
- Set UDP/IP Core IP Address
- Get UDP/IP Core IP Address
- Get UDP/IP Core Port Number
- Configuring the MPI 6000
- Tag Command Processing
- System Diagnostics and Preventive Maintenance
- Acronyms and Glossary
- Block Diagrams
- System Technical Specifications
- Hardware Interfaces
Configuration Commands and Responses
7-7
Baud Rate Data Codes
Get Communications Baud Rate
Set Communications Baud Rate Response Data
Data
Payload
Set Communications Baud Rate Command 0001H
Baud Rate
Data
Code
19,200 bps 0CH
38,400 bps (System Default) 0DH
57,600 bps 0EH
115,200 bps 0FH
Get Communications Baud Rate Command Data
Data
Pa
yload
Get Comm
unications Baud Rate Command 0002H
Get Communications Baud Rate Response Data
Data
Payload
Get Comm
unications Baud Rate Command 0002H
Baud Rate Data Code XXH
PRELIMINARY