User's Manual
Table Of Contents
- Contents
- Before You Begin
- Developing the Installation Site Plan
- Installing and Configuring the MPI 6000
- Lane Tuning Guidelines
- Optimizing MPI 6000 Reader System Performance
- General Software Information
- Configuration Commands and Responses
- Configuring the MPI 6000
- Required Commands to Set Up MPI 6000 Reader
- System Interface Command Group Commands
- System Identify
- Set Communications Baud Rate
- Get Communications Baud Rate
- Set Time and Date
- Get Time and Date
- Firmware Download
- Reset Reader
- Get Stored Tag Response Message
- Get Number of Stored Tag Response Messages
- Delete All Stored Tag Response Messages
- Get System Startup Status
- Get Lane Controller Interface Status
- Get System Interface Status
- Get DigBrd Hdwr Remote Inventory
- Get DigBrd CPU Boot Fmwr Remote Inventory
- Get DigBrd CPU Appl Fmwr Remote Inventory
- Get DigBrd FPGA UDP/IP Core Fmwr Remote Inventory
- Get UDP/IP Core Lane Controller Parameters
- Set UDP/IP Core IP Address
- Get UDP/IP Core IP Address
- Get UDP/IP Core Port Number
- Configuring the MPI 6000
- Tag Command Processing
- System Diagnostics and Preventive Maintenance
- Acronyms and Glossary
- Block Diagrams
- System Technical Specifications
- Hardware Interfaces
MPI 6000 Multi-Protocol Reader System Guide
7-10
The Firmware Download command is implemented as defined for
both UDP/IP Fast Ethernet and serial communications.
Reset Reader
Get Stored Tag Response Message
Reset Reader Command Data
Data
Payload
Reset Reader Command 0006H
Reset Reader Control Word A5A5H
Reset Reader Response Data
Data
Payload
Reset Read
er Command 0006H
Get Stored Tag Response Message Command Data
Data
Payload
Get
Stored Tag Response Message Command 0007H
Stored Tag Response Message Number XXXXH
Get Stored Tag Response Message Response Data
Data
Payload
Get
Stored Tag Response Message Command 0007H
Stored Tag Response Message Number XXXXH
Stored Tag Response Message Data
PRELIMINARY