User's Manual
Table Of Contents
- Contents
- Before You Begin
- Developing the Installation Site Plan
- Installing and Configuring the MPI 6000
- Lane Tuning Guidelines
- Optimizing MPI 6000 Reader System Performance
- General Software Information
- Configuration Commands and Responses
- Configuring the MPI 6000
- Required Commands to Set Up MPI 6000 Reader
- System Interface Command Group Commands
- System Identify
- Set Communications Baud Rate
- Get Communications Baud Rate
- Set Time and Date
- Get Time and Date
- Firmware Download
- Reset Reader
- Get Stored Tag Response Message
- Get Number of Stored Tag Response Messages
- Delete All Stored Tag Response Messages
- Get System Startup Status
- Get Lane Controller Interface Status
- Get System Interface Status
- Get DigBrd Hdwr Remote Inventory
- Get DigBrd CPU Boot Fmwr Remote Inventory
- Get DigBrd CPU Appl Fmwr Remote Inventory
- Get DigBrd FPGA UDP/IP Core Fmwr Remote Inventory
- Get UDP/IP Core Lane Controller Parameters
- Set UDP/IP Core IP Address
- Get UDP/IP Core IP Address
- Get UDP/IP Core Port Number
- Configuring the MPI 6000
- Tag Command Processing
- System Diagnostics and Preventive Maintenance
- Acronyms and Glossary
- Block Diagrams
- System Technical Specifications
- Hardware Interfaces
Configuration Commands and Responses
7-13
Get System Interface Status
Get DigBrd Hdwr Remote Inventory
Get System Interface Status Command Data
Data
Payload
Get System Interface Status Command 000CH
Get System Interface Status Response Data
Data
Payload
Get
System Interface Status Command 000CH
Module Number XXXXH
Error Number XXXXH
Get Digital Board Hardware Remote Inventory
Command Data
Data
Payload
Get Digital Board Hardware Remote Inventory Command 000DH
Get Digital Board Hardware Remote Inventory Response Data
Data
Pa
yload
Get Digital Board Hardware Remote Inventory Command 000DH
Vendor Name
Version ID
Part Number
Serial Number
PRELIMINARY