User's Manual
Table Of Contents
- Contents
- Before You Begin
- Developing the Installation Site Plan
- Installing and Configuring the MPI 6000
- Lane Tuning Guidelines
- Optimizing MPI 6000 Reader System Performance
- General Software Information
- Configuration Commands and Responses
- Configuring the MPI 6000
- Required Commands to Set Up MPI 6000 Reader
- System Interface Command Group Commands
- System Identify
- Set Communications Baud Rate
- Get Communications Baud Rate
- Set Time and Date
- Get Time and Date
- Firmware Download
- Reset Reader
- Get Stored Tag Response Message
- Get Number of Stored Tag Response Messages
- Delete All Stored Tag Response Messages
- Get System Startup Status
- Get Lane Controller Interface Status
- Get System Interface Status
- Get DigBrd Hdwr Remote Inventory
- Get DigBrd CPU Boot Fmwr Remote Inventory
- Get DigBrd CPU Appl Fmwr Remote Inventory
- Get DigBrd FPGA UDP/IP Core Fmwr Remote Inventory
- Get UDP/IP Core Lane Controller Parameters
- Set UDP/IP Core IP Address
- Get UDP/IP Core IP Address
- Get UDP/IP Core Port Number
- Configuring the MPI 6000
- Tag Command Processing
- System Diagnostics and Preventive Maintenance
- Acronyms and Glossary
- Block Diagrams
- System Technical Specifications
- Hardware Interfaces
MPI 6000 Multi-Protocol Reader System Guide
7-16
Set UDP/IP Core Lane Controller Parameters
Get UDP/IP Core Lane Controller Parameters
Firmware Remote Inventory Data
Data
Size
Vendor Name 15 Bytes
Ve
rsion ID 15 Bytes
Part Number 15 Bytes
Set UDP/IP Core Lane Controller Parameters Command Data
Data
Pa
yload
Set UDP/IP Core Lane Controller Parame
ters Command 0011H
IP Address (MSW) XXXXH
IP Address (LSW) XXXXH
Port Number XXXXH
Set UDP/IP Core Lane Controller Parameters Response Data
Data
Payload
Set UDP/IP
Core Lane Controller Parame
ters Command 0011H
Get UDP/IP Core Lane Controller Parameters Command Data
Data
Payload
Get UDP/I
P Core Lane Controller Param
eters Command 0012H
PRELIMINARY