User's Manual
Table Of Contents
- Contents
- Before You Begin
- Developing the Installation Site Plan
- Installing and Configuring the MPI 6000
- Lane Tuning Guidelines
- Optimizing MPI 6000 Reader System Performance
- General Software Information
- Configuration Commands and Responses
- Configuring the MPI 6000
- Required Commands to Set Up MPI 6000 Reader
- System Interface Command Group Commands
- System Identify
- Set Communications Baud Rate
- Get Communications Baud Rate
- Set Time and Date
- Get Time and Date
- Firmware Download
- Reset Reader
- Get Stored Tag Response Message
- Get Number of Stored Tag Response Messages
- Delete All Stored Tag Response Messages
- Get System Startup Status
- Get Lane Controller Interface Status
- Get System Interface Status
- Get DigBrd Hdwr Remote Inventory
- Get DigBrd CPU Boot Fmwr Remote Inventory
- Get DigBrd CPU Appl Fmwr Remote Inventory
- Get DigBrd FPGA UDP/IP Core Fmwr Remote Inventory
- Get UDP/IP Core Lane Controller Parameters
- Set UDP/IP Core IP Address
- Get UDP/IP Core IP Address
- Get UDP/IP Core Port Number
- Configuring the MPI 6000
- Tag Command Processing
- System Diagnostics and Preventive Maintenance
- Acronyms and Glossary
- Block Diagrams
- System Technical Specifications
- Hardware Interfaces
MPI 6000 Multi-Protocol Reader System Guide
x
Traffic Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-3
Tag Transaction or Handshake . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-4
Capture Zone or Lane Footprint . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-4
RF Factors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6
Downlink and Uplink Transmitted RF Power . . . . . . . . . . . . . . . . . . . . . . . . 4-7
Range Control Adjustments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7
Frequency Considerations — Single Protocol . . . . . . . . . . . . . . . . . . . . . . . 4-7
Frequency Considerations — Multiple Protocols . . . . . . . . . . . . . . . . . . . . . 4-8
Antenna-Tag Orientation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8
Antenna Uptilt Angle. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9
Antenna Positioning Within the Lane . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-10
Signal Timing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-11
5 Optimizing MPI 6000 Reader System Performance
Cross-Lane Interference in RFID Systems . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
What Is Cross-Lane Interference? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
Determining Acceptable Lane Performance . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
Identifying Cross-Lane Interference . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4
Diagnosing Cross-Lane Interference. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5
Remedying Cross-Lane Interference
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5
Frequency Separatio
n . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5
RF Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5
Time-Division Multiplexing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-6
Physical Remedies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-10
6 General Software Information
General Software Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-3
Plan and Organize. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-3
Communications Protocols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-3
Ethernet. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-3
Communications RS–232 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-4
Diagnostic RS–232 Serial Communications . . . . .
. . . . . . . . . . . . . . . . . . . . . . 6-5
Reader Command Protocol
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-6
UDP/IP Fast Ethernet Communications Protocol . . . . . . . . . . . . . . . . . . . . . . . 6-7
Command Request Message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-7
Data Acknowledge Message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-8
Command Response Message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-8
Asynchronous Response Message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-9
Software Flow Control Message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-10
Unsolicited Status Message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-10
Serial Communications Protocol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-11
Command Request Message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-11
PRELIMINARY