Installation Guide

6
ENGLISH
QL292
Installation
FAUCET ASSEMBLY/INSTALLATION
Spray
head
Faucet
neck
Counterweight
Hose
Faucet
outlet
Hose
Faucet outlet
Faucet body
Metal Washer
Gasket
Retaining nut
Screws
Sink
Water Supply Lines
1. Connect the faucet head to the hose. Push the hose in so that the
head aligns properly with the notches on the faucet pipe.
2. Remove the gasket, metal washer, and retaining nut from the
faucet body.
3. Install the faucet through the hole in the sink such that the faucet
body completely covers the hole.
4. From underneath, secure the faucet to the sink with the gasket,
metal washer, and retaining nut.
5. Tighten the retaining nut by hand until it is snug. Use a wrench
to tighten the assembly. Gently tighten the two screws on the
retaining nut. Do not over tighten.
6. Hand-tighten the hose to the faucet outlet. Tighten the ttings
using two wrenches. Hold the faucet outlet steady with a wrench
while turning the hose tting with another wrench until it is snug.
Failing to use two wrenches can damage the faucet. Do not over-
tighten.
7. Install the counterweight a couple of inches from the bottom of the
hose on the side closest to the faucet head. There should be no
slack in the hose.
8. Connect the water supply lines (not supplied) to the faucet.