Power Supply User Manual

User’s Guide
CPSMP-130
48-VDC Power Supply Module
CPSMP-140
24-VDC Power Supply Module
13-Slot PointSystem™ Accessory
The Transition Networks CPSMP-130 power supply is a 48-VDC slide-in-module
that provides optional, redundant power to the CPSMC1310-100 13-slot
PointSystem™ chassis and any installed media converter slide-in-modules and
management modules.
The Transition Networks CPSMP-140 power supply is a 24-VDC slide-in-module
that provides optional, redundant power to the CPSMC1320-100 13-slot
PointSystem™ chassis and any installed media converter slide-in-modules and
management modules.
The figure below illustrates the components of both types of power supplies:
• An On/Off switch that, when set to “I”, allows the power supply module
to supply power to the chassis, and any installed modules.
•A panel fastener screw that secures the power supply module to the
chassis.
•A power LED indicator.
•A handle for installing and removing the power supply module to/from
the chassis.
•A fuse installed on the circuit board inside the power supply module’s
housing.
• A set of three (3) external power connectors that distribute power from an
external DC outlet to a chassis ground connector, a positive (+)
connector, and a negative (-) connector on the power supply module.
I
0
-
+
+
+
+
+
Power LED
External Power Connector
s
On/Off Switch
Fuse
(on the circuit boar
d
I
0
-
+
Panel Fastener Scre
w
Handle
Install the Power Supply Module . . . . .3
Connect to External Power . . . . . . . . .4
Replace the Power Supply Module . . .6
Replace the Fuse . . . . . . . . . . . . . . . . .8
Technical Specifications . . . . . . . . . .10
Troubleshooting . . . . . . . . . . . . . . . .11
Contact Us . . . . . . . . . . . . . . . . . . . .11
Compliance Information . . . . . . . . . .12