- Avaya Stackable Switch Quick Start Guide

Configuring the Switch
Issue 1 September 2005 27
5. Press Enter to save the destination and gateway IP addresses.
Avaya P330 Default Settings
If you wish to change the default parameters shown and configure the mandatory parameters,
we recommend that you use the Command Line Interface (CLI).
For further information, please refer to Chapter 6 of the Avaya P330 User’s Guide.
The default settings for the Avaya P330 switch and its ports are determined by the Avaya P330
firmware. These default settings are subject to change in newer versions of the Avaya P330
firmware. See the P330 Release Notes for the most up-to-date settings.
Table 6: Default Switch Settings
Function Default Setting
IP address 149.49.32.134
BootP mode Never
Subnet Mask 255.255.255.0
Default gateway 0.0.0.0
Management PC SLIP IP Address 192.168.10.2
Management VLAN ID 1
Spanning tree Enabled
TFTP Mode Limited
TFTP Server 0.0.0.0
TFTP File Name viisa
SNMPv1 communities:
Read-only
Read-write
Trap SNMP
Public
Public
Public
SNMP authentication trap Disabled
CLI timeout 15 Minutes
User Name/Password root/root