Installation Guide

ManualsBrandsTransolid ManualsFarmhouse/Apron Kitchen SinksDiamond Farmhouse/Apron-Front Stainless Steel 36 in. Double Offset Bowl Kitchen Sink in Brushed Finish

www.transolid.com

LEGAL DISCLAIMER

All technical data and information provided in this publication is done as a public service to customrs of Transolid

and consumers of our products. All

names, designs, and model numbers of products are trademarks of Transolid

. Prices and specications of Transolid’s products are subject to change

without notice or obligation. Transolid

may also change or discontinue models of its products without notice or obligation. While Transolid

endeavors

to provide you with accurate information and descriptions of its products, accuracy and completeness cannot be guaranteed. Transolid

is not respon-

sible for, nor does it have any liability for any mistakes or typographical errors, including liability for incidental, consequential, or special damages. All

products should be inspected and measured promptly upon delivery and certainly before any improvements or alterations are done in anticipation of

or preparation for installation. Transolid

assumes no liability for the use of such information or for any damages incurred through its use or application.

Nothing contained in this publication is to be construed as contractual or providing any form of warranty or representation on the part of Transolid

TRANSOLID

MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABI-

LITY OR OF FITNESS FOR A PARTICULAR PURPOSE, AS TO THE INFORMATION CONTAINED HEREIN OR THE PRODUCTS DESCRIBED

HEREIN.

4. Install the Sink

Lower the sink onto the supports; verify the sink is

supported by the frame.

Push the sink in to ensure the apron is ush to the

front of the cabinet.

Verify the sink is level; make any adjustments and

shim as needed.

5. Install the Countertop

Clean the bottom of the countertop and top ange

(or lip) of the sink with denatured alcohol. Then ap-

ply a narrow bead of high quality silicone adhesive

sealant to the top edge of the sink ange.

Apply a bead of high quality silicone adhesive

around the side and back of the sink.

Place the countertop on the sink.

Remove any excess sealant from the inside lip

of the sink using a cleaner recommended by he

sealant manufacturer and allow it to properly cure

following sealant manufacturer’s recommended in-

structions.

Install the faucet and strainers according to

installation instructions.

Connect the trap to the strainers.