Installation Guide

ManualsBrandsTransolid ManualsDrop-in Kitchen SinksMeridian All-in-One Drop-In Stainless Steel 33 in. 1-Hole Single Bowl Kitchen Sink in Brushed Stainless Steel

www.transolid.com

sink

outline

LEGAL DISCLAIMER

All technical data and information provided in this publication is done as a public service to customrs of Transolid

and consumers of our products. All

names, designs, and model numbers of products are trademarks of Transolid

. Prices and specications of Transolid’s products are subject to change

without notice or obligation. Transolid

may also change or discontinue models of its products without notice or obligation. While Transolid

endeavors

to provide you with accurate information and descriptions of its products, accuracy and completeness cannot be guaranteed. Transolid

is not respon-

sible for, nor does it have any liability for any mistakes or typographical errors, including liability for incidental, consequential, or special damages. All

products should be inspected and measured promptly upon delivery and certainly before any improvements or alterations are done in anticipation of

or preparation for installation. Transolid

assumes no liability for the use of such information or for any damages incurred through its use or application.

Nothing contained in this publication is to be construed as contractual or providing any form of warranty or representation on the part of Transolid

TRANSOLID

MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABI-

LITY OR OF FITNESS FOR A PARTICULAR PURPOSE, AS TO THE INFORMATION CONTAINED HEREIN OR THE PRODUCTS DESCRIBED

HEREIN.

7. From the underside of the sink, place one clamp near the center

and tighten by hand enough to hold the sink in place. This applies

to all four sides. Fastening remaining clamps in position and hand

tighten. Space clamps as equally as possible. Provided hardware

will accommodate countertops thicker than 3/4” up to 1-1/2”.

NOTE: Do not fully tighten one clip at a time. Partially tighten a clip,

then partially tighten the clip across from it. After each clip is par-

tially tightened, repeat the process, fully tightening each clip. This

ensures a secure installation and avoids damage to the sink.

8. Remove any excess caulk and allow it to properly cure following

caulk manufacturer’s recommended instructions.

Install supply lines to water sources, drain ttings, and other items.

Create your own template

1. Position sink upside down on countertop surface. Take into con-

sideration adequate clearance for the faucet, backsplash, and any

accessories such as a soap/lotion dispenser. Place sink in exact po-

sition for installation and with a pencil draw a line completely around

sink to create a sink outline.

2. Scribe actual opening 5/16” inside the sink outline, all the way

around. Cut out on inside of this line (following the countertop man-

ufacturer’s instructions).

Continue to Step 3 on previous page and follow remaining top mount

installation instructions.