Installation Guide

10
www.transolid.com 800-766-2452 TRANSOLID
®
Installation Procedure
Temporary Bracing continued
4. Insert small blocks between the front-to-rear panel braces and
the back panel braces. These will apply pressure to the back pan-
el to hold it in place.
For corner shower wall installation use the following illustrated
bracing design.
ATTENTION: Additional bracing may be required if the Transolid
®
panel does not make full contact to the wall it is adhered to.
5. Remove the braces after 24 hours.
Corner Molding
1. Measure and cut the corner moldings to length.
2. Dry t the corner molding.
WARNING
Fumes Hazard
The fumes from the silicone and solvents used by the
installer can be harmful if used in an unventilated room.
Always work in a well-ventilated area. To keep the area
well-ventilated, open windows and use exhaust fans. If ad-
equate ventilation is not achievable or practical, use res-
piratory protective equipment.
3. Clean the surface of the panels and the back of the molding
with denatured alcohol or another non-oil based solvent.
IMPORTANT NOTICE
Do not use oil-based cleaners, such as mineral spirits, to clean
the panels. The oil in the cleaner will prevent the panel from
adhering properly to the wall.
Attach this
board to
the wall
Attach this
board to
the wall
These boards need to be attached
to the two outlying boards