Installation Guide

www.transolid.com 800-766-2452 TRANSOLID

Installation Procedure

Side Panel (with shower controls) continued

6. Place the panel, nished side facing up, on a at surface.

Transfer the measurements to the panel.

7. Cut clearance holes using a router, saber saw, or hole saw.

Drill or cut from the nished side of the panel. For best results,

when drilling, place a scrap of wood beneath the hole to ensure

a clean cut.

8. Dry t the panel, and make any necessary adjustments.

Side Panel (without shower controls)

If the panel does not require cutting to size, proceed to the next

section.

1. Place the panel on top of the shower base and slide it against

the back wall panel. If the side panel has only one nished edge,

make sure that the nished edge is facing out.

2. Scribe (mark) the panel, as shown. If the panel is wider than

the wall, take this width into consideration when scribing the

panel.

Note: Precisely scribing and cutting the panel will provide a

clean 90 degree corner with no need for corner molding.

3. Place the panel, nished side facing up, on a at surface. Place

pieces of masking tape over the area where the saw contacts the

Transolid

panel.

WARNING

Dust Hazard

When cutting or drilling the Transolid

Expressions product,

use a dust collection method which prevents dust particles

from going into the air. Always work in a well ventilated area.

To keep the area well ventilated, open windows and use ex-

haust fans. Always use an OSHA approved dust mask when

cutting, drilling, or sanding Transolid

products.

4. Cut the panel using a circular saw with a 60-80 tooth carbide

blade or a saber saw with bi-metal blade (14 teeth per inch).

5. Dry t the panel, and make any necessary adjustments.