Installation Guide

11
TRANSOLID
®
800-766-2452 www.transolid.com
Installation Procedure
4. Apply an 1/8 to 1/4” bead of silicone to the back of the corner
molding in an S pattern, as shown.
5. Press the corner moldings into place. Remove any excess
silicone.
6. Place at least three pieces of masking tape on each corner mold-
ing to hold it in place until the silicone adheres to the wall panel.
Final Caulking
Apply a bead of 100% silicone sealant.
IMPORTANT NOTICE
Follow the manufacturer’s instructions on the tube for proper
application. Allow at least 24 hours for silicone to set before us-
ing the shower enclosure.
1. Apply 100% silicone sealant to all inside seams, as shown.
2. Apply 100% silicone sealant to the exterior edges, as shown.
This silicone sealant is non-paintable.
The installation is now complete. DO NOT discard these in-
stallation instructions. Please leave with the homeowner.
Attaching Showers Doors and Accessories
1. Follow the mounting instructions that come with shower door
and each accessory.
2. Drill pilot holes slightly larger than the fasteners, where fas-
teners pass through the wall panels.
3. If anchors are being used, drill the hole in the panel large
enough for the head of the anchor to t through the panel and
the structural wall behind it.
4. Use 100% clear silicone to seal any holes or joints between
the accessory and the wall panel.
Care and Cleaning
Transolid Saramar
®
solid surface products are stain and abra-
sion resistant; however, the nish requires reasonable care.
IMPORTANT NOTICE
Because cleaning products change over time, always check the
manufacturer’s instructions to make sure it is compatible with
solid surface acrylic. DO NOT use a cleaner if the label indi-
cates it should not be used on solid surface acrylics. DO NOT
use spray-on cleaners that require daily use without immedi-
ately rinsing with water to stop the chemical cleaning reaction
because damage will result and void the warranty.
Day-To-Day Clean-up
Simply wipe the surface with a clean towel to remove watermarks
and residues. All Transolid Saramar
®
products can be cleaned
with warm water, a soft cloth, and normal household detergents
or cleansers, such as Clorox Clean-up, Mr. Clean,Dow Scrub-
bing Bubbles, Formula 409. Always rinse off cleaners within ve
minutes of application.
Occasional scrubbing with household abrasive cleaners en-
sures that the original luster is maintained.
Caulking Joints
Inspect caulking joints monthly for damage or any signs of sep-
aration from the mating surface. Cracks in the caulking will allow
water to leak into the surrounding surfaces. Reapply caulking
to any joint showing signs of wear or cracking. Failure to
inspect and repair caulking joints will void the warranty.