User's Manual
Table Of Contents
- Start Radio
- Soft Reset
- Force MIU Read
- LED Indicators
- Green LED will flash during every radio transmission. This will only take place for one minute after a Radio Start and/or a Force MIU Read.
- Red LED will flash during every radio transmission that has a tamper count (a failure to obtain an error-free reading of the MIU). This will only take place for one minute after a Radio Start and/or a Force MIU Read.
- LED Indicators
M
M
1
1
Utility
Radio
Transmitter
INSTALLATION
THIS
END
UP
The M1 can be installed either in indoor
or outdoor environments. The unit is
100% waterproof.
The M1 should always be installed vertically.
The backside of the unit indicates the proper
orientation.
For best transmission, the unit should not be
mounted directly on any metal surfaces, such as
pipes or valves. If mounting in a pit or vault, the
unit should be at least 8 inches
below the lid.
W
IRING
The M1 utilizes the defacto-standard ECR-II
communications protocol and standard wiring
conventions
Red: Clock/PWR
Green: Data
Black: Ground
The unit can be ordered with a pre-wired
cable in 5-ft increments or with leads ready
for splicing in the wiring chamber.
Transparent Technologies, Inc.
www.transparenttech.com
Wiring Chamber
Cable Exit