User Manual

Revision - 1.0
7
Intrinsic Safety Wiring Information
All wiring should be performed to CEC and NEC standards, as well as any additional local standards.
Cable diameter should fall within 3.0 to 6.0 mm to ensure IP rating is maintained.
The three-pin connector on the TIM Plus is an IS connection as identified by the label on the side of
the case.
Please see below for pin layout. Ensure that the pins are connected properly before plugging in the
connector.
Refer to the label for all relevant entity parameters to maintain IS certification.
Protective Cover
TRIG offers a protective cover for both the TIM Basic and TIM Plus (A covering is required for the TIM
Plus). This cover come pre-installed when bought from TRIG.
FIGURE 5 CONNECTION ON TIM PLUS
Signal
Power
Ground
FIGURE 6 EXTERNAL THREE PIN CONNECTOR
Protective
Cover