User's Manual

WiMAX Quick Configuration Guide 20
Figure 11. Configuration subtab on Device Interfaces Details tab.
The figure above shows the default values to configure the Pico
Base Station to be connected to a single Subscriber Unit. If you wish
to connect more than one Subscriber Unit please modify the Frame
Length to 10 or 20 ms. 10ms is the recommended value. Although
the latency will increase, the supported throughput will increase. In
addition change the Minimum Size of First Burst value under the
MAC_GRP tab. The recommended burst size values are shown below
in Table 5: Minimum Size of First Burst for multiple Subscriber
Units.
Table 5: Minimum Size of First Burst for multiple Subscriber Units.
Number of
Subscriber Units
Minimum Size
of First Burst
1 25
2 27
3 28
4 30