User's Manual

WiMAX Quick Configuration Guide 7
4. In the left pane, under Administration, click Initial configuration. The
Initial Base Station Configuration page appears.
Figure 2. Initial Base Station configuration page.
5. Change the Bridge IP Address to match the IP address schema of your
network. The IP address must be on the same subnet as the AirSync server.
6. Complete the remaining fields on the screen.
The Frequency [khz] and Channel bandwidth [MHz] settings must match the
settings that you will configure later for the Subscriber Unit.
7. When finished, click Apply to save your settings. The Saving Settings screen
appears, with a Reboot button for rebooting the Pico Base Station. You must
reboot to apply your settings.
1.3 Step 2: Configure the Subscriber Unit
After configuring the Pico Base Station, use the procedures in the following sections
to configure the Subscriber Unit.