User's Manual

WiMAX Quick Configuration Guide 8
1.3.1 Log in to the Configurator
Your Subscriber Unit provides a Web-based Configurator for performing advanced
configuration activities. After you install your Subscriber Unit, use the following
procedure to launch the Configurator.
1. Use an Ethernet cable to connect the Ethernet port labeled PC on the PoE
adapter to a network-interface card (NIC) in a PC or network hub. Then
connect the other Ethernet port on the PoE adapter to the Subscriber Unit.
The Subscriber Unit’s Ethernet port is equipped with an auto-sensing Ethernet
port that allows both regular and cross-over cables to be used.
2. Start your Web browser and point it to one of the following default IP
addresses: http://192.168.101.151 or http://192.168.0.1. The Login
page in Figure 3 appears, with your cursor in the User name field.
The default IP address is the same for all TR-WMX subscriber units. Therefore, do
not simultaneously connect multiple unconfigured TR-WMX subscriber units to a
common Local Area Network (LAN) and try to access them using the default IP
address.
To connect to the Configurator, your PC’s IP address must be on the same subnet
(192.168.101.xxx, where xxx is a number from 1 to 253) as the Subscriber Unit,
and the PC’s netmask must be set to 255.255.255.0.
Figure 3. Login page.
3. Enter the default username admin and default case-sensitive password
default in the appropriate fields.