User's Manual

Chapter 16: Quality of Service (QoS) Configuration
TR0153 Rev. E1 125
Figure 54. Advanced QoS configuration (only settings for some interfaces are shown)
16.2 Rate Limiting
A rate limit can be set at each QoS Control Point shown in Figure 55. The Control Points can
be split into three groups, listed below in decreasing order of importance:
• Interface output limit
• Interface output limit of traffic from a particular interface
• Interface output limit of traffic of a certain type from a particular interface
All rate limit parameter values are in kbps. If no rate limit parameter is set, rate
limiting will be disabled for that interface or interface and traffic combination.
The maximum output data rate for interfaces can be limited with the Output Limit parameters
for each client access interface. The default output limit value is applied to interfaces that have
the Output Limit parameter set to ‘inherit’.