User's Manual

Chapter 1: Working with the EnRoute500
TR0153 Rev. E1 13
Interface Description
Power (EnRoute 5x1 only) Power input (100-240VAC 50-60 Hz)
Mesh radio port N-type antenna connector for mesh radio
AP radio port N-type antenna connector for access point radio
Ethernet 10/100 Mbit Ethernet interface
Passive PoE
PoE power input (9-28VDC, 12W)
Not compatible with IEEE 802.3af
Table 2. EnRoute500 Interfaces
1.5.1 Ethernet and PoE
The EnRoute500 has a 10/100 Ethernet port that supports passive Power over Ethernet (PoE).
The PoE power injector should supply an input voltage between 9-28VDC and a minimum of
12W. The pinout for the Ethernet interface on the EnRoute500 is provided in Table 3.
The EnRoute500 is equipped with an auto-sensing Ethernet port that allows both
regular and cross-over cables to be used to connect to it.
Pin Signal Standard Wire Color
1 Tx+ White/Orange
2 Tx- Orange
3 Rx+ White/Green
4 PoE V+ Blue
5 PoE V+ White/Blue
6 Rx- Green
7 Gnd White/Brown
8 Gnd Brown
Table 3. Ethernet port pinout
To power the EnRoute500, connect an Ethernet cable from the Ethernet port of the
EnRoute500 to the port labeled “CPE” on the supplied PoE injector and apply power to the
PoE injector using the supplied power supply