User's Manual

Chapter 18: Integration with Enterprise Equipment
TR0153 Rev. E1 132
must be in the range from 0 to 4095. Note that 0 and 4095 are reserved values and 1 is the
default VLAN ID.
CLI
The example below shows how to enable VLAN tagging on the backhaul interface on a
gateway device using the ‘vlan.enable’ parameter in the ‘eth0’ interface.
> use eth0
eth0> set vlan.enable=yes
The example below shows how to set the VLAN ID for the backhaul Ethernet interface using
the ‘vlan.id’ parameter in the ‘eth0’ interface.
> use eth0
eth0> set vlan.id=1
Web GUI
The backhaul VLAN parameters are set on the “Wired/Backhaul Interface” page as shown in
Figure 58.
Figure 58. Configuring VLAN for backhaul interface