User's Manual

Chapter 8: System Settings
TR0153 Rev. E1 61
CLI
The cluster name is set with ‘info.cluster’ parameter in the ‘sys’ interface. This parameter can
be set as shown in the example below.
> use sys
sys> set info.cluster=”Campus network”
Web GUI
The cluster name can be set via the web interface using the “Location” tab on the “System
Parameters” page (see Figure 31). Use the “Cluster Name” field to set the cluster name.
8.13 Certificate Information
A certificate for use with splash pages and the web interface is locally generated on the
EnRoute500. The information embedded in this certificate can be defined by the user. A new
certificate is automatically generated when the parameters describing the EnRoute500’s
location are changed. The specific location parameters to which the certificate is tied to are
listed in the sections below.
CLI
The information used in certificate generation can be set using the ‘organization’ parameters in
the ‘sys’ interface. These parameters are:
• sys.organization.name –name of organization (must be enclosed in quotes if it contains
spaces)
• sys.organization.city – city name (must be enclosed in quotes if it contains spaces)
• sys.organization.state – state name
• sys.organization.country – two-letter country abbreviation
Web GUI
The certificate information can be set via the web interface using the “Location” tab on the
“System Parameters” page (see Figure 31). Changing any of the Organization, City,
State/Province, or Country parameters will cause the certificate information to be recalculated.
8.14 Time Synchronization
An EnRoute500 configured as a gateway can be configured to synchronize its internal clock
with an external RFC-868-compliant time server. Devices configured as repeaters will