User's Manual

Chapter 12: Virtual Access Point (VAP) Configuration
TR0153 Rev. E1 86
ip.netmask_force =
ip.implicit.size.actual = [read-only]
ip.implicit.size.requested = 31
ip.implicit.start.actual = [read-only]
ip.implicit.start.requested = 1
When an EnRoute500 is using the implicit addressing scheme, the VAP IP settings can be
changed by altering the ‘id.node’, ‘id.mesh’, and ‘id.lanprefix’ parameters in the ‘sys’ interface
and the ‘ip.implicit.start.requested’ parameter in the appropriate ‘wlanN’ interface.
When an EnRoute500 is using the explicit addressing scheme, the IP address, netmask,
gateway address, and broadcast address can be set using the ‘ip.address_force’,
‘ip.netmask_force’, ‘ip.gateway_force’, and ‘ip.broadcast_force’ parameters in the appropriate
‘wlanN’ interface as shown in the example below.
> use wlan1
wlan1> set ip.address_force=10.12.8.1
wlan1> set ip.broadcast_force=10.12.8.255
wlan1> set ip.gateway_force=
wlan1> set ip.netmask_force=255.255.255.0
Web GUI
The current VAP IP settings can be viewed through the web interface on the “Config Overview”
tab on the “Status” page. When using the implicit addressing scheme, the VAP IP settings can
be changed by altering the node ID, mesh ID, and LAN prefix settings on the “System”
parameters tab on the “System Parameters” page. When using the explicit addressing
scheme, the IP parameters can be set on the appropriate tab on the “Wireless Interface” page.