User's Manual

iiiiiiiii
This document is intended for Public Distribution
19473 Fraser Way,
Pitt Meadows, B.C. Canada V3Y 2V4
Safety Information
iii
TR-5A Series
Tranzeo Wireless Technologies
This device has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the device is operated in a residential
environment. This device generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the user guide, may cause harmful interference to radio
communication. In case of harmful interference, the users will be required to correct the
interference at their own expense.
The users should not modify or change this device without written approval from Tranzeo
Wireless. Modification will void warranty and authority to use the device.
For safety reasons, people should not work in a situation where RF exposure limits could be
exceeded. To prevent this situation, the users should consider the following rules:
• Install the antenna so that there is a minimum of 100 cm (39.37 in) of distance between
the antenna and people. The TR-5amp series requires 268 cm (105.5 in) between the
antenna and people.
• Do not turn on power to the device while installing the antenna.
• Do not connect the antenna while the device is in operation.
• Do not collocate or operate the antenna used with the device in conjunction with any
other antenna or transmitter.
• This device has been designed to operate with the antennas listed below, and having a
maximum gain of 32 dB. Antennas not included in this list or having a gain greater
than 32 dB are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.
TR-GD58-26 – 5.8 GHz 26 dBi Grid antenna
TR-HTQ-5.8-12 – 5.8 GHz 12 dBi Omni antenna
TR-58V-60-17 – 5.8 GHz 17 dBi Sector antenna
TR-58H-90-16 – 5.8 GHz 16 dBi Sector antenna
TR-5.8-32db-ant—5.8 GHz 32dBi Dish antenna
• In order to ensure compliance with local regulations, the installer MUST enter the
antenna gain at the time of installation. See Chapter 3: Wireless Settings, for details.
FCC Compliance
Safety Information
Operation of this device is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Industry Canada Compliance