User's Manual

EnRoute50x/51x User’s Guide
TR0153 Rev. D2
46
Figure 24. Setting the NetBIOS server(s)
6.9 Location
Two types of node location information can be stored:
Latitude/longitude/altitude
Postal address or description a node‟s location
Note that these values are not automatically updated and must be entered after a node has
been installed. Altitude is in meters. Latitude and longitude must be given in geographic
coordinates, with latitude ranging from -90 to 90 (with negative being south, positive being
north) and longitude ranging from -180 to 180 (with negative being west, positive being east).
CLI
The GPS location of the node can be stored in the following fields in the „sys‟ interface:
sys.location.gps.altitude
sys.location.gps.latitude
sys.location.gps.longitude
For example, you can set the latitude value as follows.
> use sys
sys> set location.gps.latitude=”34.01”