User's Manual

EnRoute50x/51x User’s Guide
TR0153 Rev. D2
70
use by statically configured devices. The remaining IP addresses in the interfaces address
space can be assigned by the DHCP server to other client devices.
CLI
The number of IP addresses reserved for statically-configured devices connected to the
Ethernet interface is set with the „dhcp.reserve‟ parameter in the „eth0‟ interface.
Web GUI
The „dhcp.reserve‟ value can be set via the web interface using the “DHCP” sub-tab on the
“DHCP” tab on the “System Parameters” page (see Figure 33).
9.7 Client Devices
Each access point has a status page that displays information about attached clients and total
throughput through the access point. The signal strength of each client device, it‟s MAC
address, its IP address, and the time since data was last received from it are listed. The status
pages can be accessed under the „Status‟ tab on the „Status‟ page, as shown in Figure 34.
Figure 34. Access point client status information
9.8 Encryption and Authentication
The EnRoute500 supports several common encryption/authentication schemes, including
WEP, WPA, and WPA2, to provide secure wireless access for client devices. WEP keys with
40-bit or 104-bit lengths, pre-shared WPA keys, and multiple WPA-EAP modes.