Operation Manual

System Services Commands 4 – 19

System Services Commands

Use system services commands to configure and monitor system information for a Mobility

Exchange (MX) switch. This chapter presents system services commands alphabetically. Use the

following table to located commands in this chapter based on their use.

clear banner motd

Deletes the message-of-the-day (MOTD) banner that is displayed before the login prompt for each

CLI session on the MX switch.

Configuration quickstart on page 4-23

Auto-Config set auto-config on page 4-23

New Run Scripts set run on page 4-29

clear run on page 4-21

Display clear banner motd on page 4-19

set banner motd on page 4-26

set banner acknowledge on page 4-25

show banner motd on page 4-36

set confirm on page 4-26

set length on page 4-27

System Identification set prompt on page 4-28

set system name on page 4-36

Updated set system location on page 4-35

New set system console-timeout on page 4-29

Updated set system contact on page 4-30

set system countrycode on page 4-30

set system idle-timeout on page 4-34

set system ip-address on page 4-35

show load on page 4-37

Updated show system on page 4-40

Updated clear system on page 4-21

clear prompt on page 4-20

Updated Help help on page 4-22

History history on page 4-23

clear history on page 4-20

Updated License set license on page 4-27

show license on page 4-37

Technical Support show tech-support on page 4-42