Operation Manual

MP Access Point Commands

12 – 235

MX that has the greatest capacity to add more active MPs. For example, if an MP is dual homed to

two MX-400 switches, and one of the switches has 50 active MPs while the other MX has 60 active

MPs, the new MP selects the MX that has only 50 active MPs.

If the boot request on MP port 1 fails, the MP attempts to boot over its port 2, using the same

process described above.

The following command changes the bias for a Distributed MP to low:

MX# set ap 1 bias low

success: change accepted.