Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 295
When 40-bit WEP in RSN or WPA is enabled in the service profile, radios managed by a radio
profile that is mapped to the service profile can also support non-WPA clients that use dynamic
WEP.
To support WPA clients that use 104-bit dynamic WEP, you must enable WEP with 104-bit keys in
the service profile. Use the set service-profile wpa-ie cipher-wep104 command.
Microsoft Windows XP does not support WEP with WPA. To configure a service profile to provide
dynamic WEP for XP clients, leave WPA disabled and use the set service-profile wep
commands.
To support non-WPA clients that use static WEP, you must configure static WEP keys. Use the set
service-profile wep key-index command.
Examples The following command configures service profile sp2 to use 40-bit WEP encryption:
MX# set service-profile sp2 wpa-ie cipher-wep40 enable
success: change accepted.
See Also
● set service-profile [rsn-ie | wpa-ie ]cipher-ccmp on page 12-292
● set service-profile [rsn-ie | wpa-ie] cipher-tkip on page 12-293
● set service-profile [rsn-ie | wpa-ie] cipher-wep104 on page 12-293
● set service-profile wep key-index on page 12-320
● set service-profile wpa-ie on page 12-321
● show service-profile on page 12-357
set service-profile cos
Sets the Class-of-Service (CoS) level for static CoS.
Syntax set service-profile profile-name cos cos
Defaults The default static CoS level is 0.
Access Enabled.
History Introduced in MSS Version 4.2.
Usage This command applies only when static CoS is enabled. If static CoS is disabled,
prioritization is based on the QoS mode configured in the radio profile, and on any ACLs that set
CoS. (See the “Configuring Quality of Service” chapter of the Trapeze Mobility System Software
Configuration Guide.) To enable static CoS, use the set service-profile static-cos command.
Examples The following command changes the static CoS level to 7 (voice priority):
MX# set service-profile sp1 cos 7
success: change accepted.
See Also
● set service-profile static-cos on page 12-311
● show service-profile on page 12-357
profile-name Service profile name.
cos CoS value assigned by the MP to all traffic in the service
profile.