Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 342
MX# show ap status 9991
Flags: o = operational[0], c = configure[0], d = download[0], b = boot[0]
x= down a = auto AP, m = mesh AP, p/P = mesh portal (ena/actv), r = redundant[0]
i = insecure, e = encrypted, u = unencrypted
Radio: E = enabled - 20MHz channel, S = sentry
W/w = enabled - 40MHz wide channel (HTplus/HTminus)
D = admin disabled
IP Address: * = AP behind NAT
AP Flag IP Address Model MAC Address Radio 1 Radio 2 Uptime
---- ---- --------------- ------------ ----------------- ------- ------- ------
9991 oa-i 129.0.1.10 MP-422 00:0b:0e:00:1b:00 E 6/22 D 44/18 03d21h
The following command uses the verbose option to display all information for MPs:
MX# show ap status verbose
Rack28-2800-112226# show ap status 9991 verbose
AP: 9991 Name: AUTO-9991
Model: Trapeze MP-422, Rev: n/a, Serial number: 108
F/W1 : 1.0
F/W2 : 1.0
S/W : 7.0.1.0.private_032408_1529_jperson
BOOT S/W : <unknown>
IP-addr: 129.0.1.10 (DHCP, vlan 'apboot'),
Port 1 link: 10/Half , POE: 802.3af
Port 2 link: down , POE: 802.3af
State: operational (encrypted and fingerprint not verified)
Uptime: 3 days, 21 hours, 41 minutes, 28 seconds
Radio 1 Type: 802.11g, State: configure succeeded [Enabled]
Operational channel: 6 (Auto) Operational power: 22
Load balance: enabled, Current load: (unavailable)
RFID reports: Inactive
BSSID1: 00:0b:0e:00:1b:00, SSID: sim-open
Radio 2 Type: 802.11a, State: configure succeeded [Disabled]
Operational channel: 44 (Auto) Operational power: 18
Load balance: enabled, Current load: (unavailable)
RFID reports: Inactive
Table 12– 8 and Table 12– 9 describe the fields in these displays.