Operation Manual

RF Detection Commands
Mobility System Software Command Reference Guide
Version 7.3
20 – 470
Syntax set rfdetect ssid-list [ssid-name | ssid*]
Defaults The permitted SSID list is empty by default and all SSIDs are allowed. However, after
you add an entry to the list, MSS allows traffic only for the listed SSIDs.
Access Enabled.
History
Usage
The permitted SSID list applies only to the MX with the configured list. MX switches do
not share permitted SSID lists.
If you add a device that MSS has classified as a rogue to the permitted SSID list, but not to the
ignore list, MSS can still classify the device as a rogue. Adding an entry to the permitted SSID list
merely indicates that the device is using an allowed SSID. However, if you want MSS to stop
classifying the device as a rogue, you must add the device MAC address to the ignore list.
Examples The following command adds SSID mycorp to the list of permitted SSIDs:
MX# set rfdetect ssid-list mycorp
success: ssid mycorp is now in ssid-list.
See Also
● clear rfdetect ssid-list on page 20-463
● show rfdetect ssid-list on page 20-480
set rfdetect vendor-list
Deprecated in MSS Version 6.2.
show rfdetect classification
Displays information about the RF detect classifications configured on the network.
Syntax show rfdetect classification
Defaults None
Access Enabled
History Introduced in MSS 6.2
Examples The following shows the RF detect classification on the MX.
MX# show rfdetect classification
User Rul
ssid-name SSID name you want to add to the permitted SSID list.
ssid* SSID glob to add to the permitted SSID list.
MSS Version 4.0 Command introduced.
MSS Version 6.2 Added the ability to use wildcards for SSID names.
User
Rule
Rules for Classifiation Classification
N If in Rogue list Rogue
N If AP is part of Mobility Domain Member