User guide

TABLE OF CONTENTS
I. THE SERIAL TAG Page 1
II. RECEIPT INSPECTION Page 2
III. INSTALLATION
a-Location Page 2
b-Packaging Page 2
c-Installing Legs or Casters Page 2
d-Tray Slides Page 2
e-Cord & Plug Page 3
f-Power Supply Page 3
g-Wiring Diagram Page 3
h-Clearance Page 3
IV. OPERATION
a-Even-Thaw Overview Page 3
b-Expected Performance Page 3
c-Even-Thaw Operation Page 3
d-Batch Loading Page 3
e-Process Loading Page 3
f-Interior Arrangements Page 3
g-Adjusting The Temperature Scale Page 4
h-Operator Controls, Blower Switch Page 4
i-Call Service Light Page 4
V. CARE & MAINTENANCE
a-Cleaning The Condenser Page 4
b-Hinge Replacement Page 4
c-Replacing The Gaskets Page 5
d-Cleaning The Exterior Page 5
e-Cleaning The Interior Page 5
The serial tag is a permanently affixed sticker on
which is recorded vital electrical and refrigeration data
about your Traulsen product, as well as the model
and serial number. This tag is located in the upper
right interior compartment on all reach-in/pass-thru
and roll-in/roll-thru refrigerator, freezer and dual-temp
models. For hot food models, this tag is located on
the top of the unit behind the louvers to protect it
from the heat.
I. THE SERIAL TAG
-1-
FORT WORTH, TX.
SERIAL MODEL
VOLTS Hz PH
TOTAL CURRENT AMPS
MINIMUM CIRCUIT AMPS
MAXIMUM OVERCURRENT PROTECTION AMPS
LIGHTS WATTS
HEATERS AMPS
REFRIGERANT TYPE OZ
DESIGN PRESSURE HIGH LOW
REFRIGERANT TYPE OZ
DESIGN PRESSURE HIGH LOW
370-60294-00 REV (A)
READING THE SERIAL TAG
• Serial = The permanent ID# of your Traulsen
• Model = The model # of your Traulsen
• Volts = Voltage
• Hz = Cycle
• PH = Phase
• Total Current = Maximum amp draw
• Minimum Circuit = Minimum circuit ampacity
• Lights = Light wattage
• Heaters = Heater amperage (Hot Food units only)
• Refrigerant = Refrigerant type used
• Design Pressure = High & low side operating
pressures and refrigerant charge
• Agency Labels = Designates agency listings
VI. OTHER
a-Service Information Page 5
b-Spare Parts Page 5
c-Warranty Registration Page 5
VII. GEN’L USE, OPERATION & SERVICE SUMMARY Page 6
VIII. EXPECTED THAW PERFORMANCE/
OPERATIONAL TROUBLESHOOTING
a-Introduction Page 7
b-Test Parameters Page 7
c-Test Results Page 7
d-Results as a Function of Product Mix Page 7
e-Incomplete Thawing Page 7
f-Equipment Issues Page 7
g-Other Causes Of Extended Thaw Times Page 7-8
IX. TROUBLE SHOOTING GUIDE Page 8
X. SPARE PARTS LIST Page 9
XI. WIRING DIAGRAM - ALL ONE SECTION MODELS Page 10
XII. WIRING DIAGRAM - MODELS RET232NUT ONLY Page 11
XIII. WIRING DIAGRAM - MODELS RET232EUT ONLY Page 12
XIV. WARRANTY INFORMATION Page 13
XV. INDEX Page 14