User Guide

TABLE OF CONTENTS
The serial tag is a permanently affixed sticker on
which is recorded vital electrical and refrigeration data
about your Traulsen product, as well as the model
and serial number. This tag is located in the upper
right interior compartment on all reach-in/pass-thru
and roll-in/roll-thru refrigerator, freezer and dual-temp
models. For hot food and proofer models, this tag is
located on the top of the unit behind the louvers to
protect it from the heat.
I. THE SERIAL TAG
-1-
FORT WORTH, TX.
SERIAL MODEL
VOLTS Hz PH
TOTAL CURRENT AMPS
MINIMUM CIRCUIT AMPS
MAXIMUM OVERCURRENT PROTECTION AMPS
LIGHTS WATTS
HEATERS AMPS
REFRIGERANT TYPE OZ
DESIGN PRESSURE HIGH LOW
REFRIGERANT TYPE OZ
DESIGN PRESSURE HIGH LOW
370-60294-00 REV (A)
READING THE SERIAL TAG
• Serial = The permanent ID# of your Traulsen
• Model = The model # of your Traulsen
• Volts = Voltage
• Hz = Cycle
• PH = Phase
• Total Current = Maximum amp draw
• Minimum Circuit = Minimum circuit ampacity
• Lights = Light wattage
• Heaters = Heater amperage (Hot Food units only)
• Refrigerant = Refrigerant type used
• Design Pressure = High & low side operating
pressures and refrigerant charge
• Agency Labels = Designates agency listings
I. THE SERIAL TAG Page 1
II. RECEIPT INSPECTION Page 2
III. INSTALLATION
a-Location Page 2
b-Packaging Page 2
c-Roll-In Model Installation Page 2
d-Wiring Diagram Page 2
e-Power Supply Page e
f-Clearance Page 3
IV. CARE & MAINTENANCE
a-Cleaning The Exterior Page 3
b-Cleaning The Interior Page 3
c-Hinge Replacement Page 3
d-Replacing The Gaskets Page 3
V. OTHER
a-Service Information Page 3
b-Spare Parts Page 4
c-Warranty Registration Page 4
d-Interior Arrangements Page 4
VI. PIZZA PROOFER OPERATION
a-Controls Page 4
b-ON/OFF Switch Page 4
c-Proofing Page 4
VII. TROUBLE SHOOTING GUIDE Page 5
VIII. WIRING DIAGRAM Page 6
IX. WARRANTY INFORMATION Page 7