Instruction Manual

CQL1586-B Disco Ball Speaker

Instruction Manual (Read before proceeding)

FCC Statement:

Changes or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Charging the Speaker

 Plug the small connector of the included USB charging cable into the USB Charging port on the speaker’s

control panel. Plug the large connector into the USB port on a computer, a USB charging device, or a 5V

USB adapter (not included) and plug into a wall socket.

 The LED indicator will turn RED while charging and turn off when fully charged. When low on power, a tone

will be heard , indicating that the speaker should be charged.

CONTROL PANEL

1. [POWER] Switch

2. Charging LED Indicator

3. Micro USB Charging Port

4. LED Indicator

Bluetooth Speaker Operation

 Turn on the unit by pushing the switch to “ON” position. The LED

light on top will light on indicate the speaker is in paring mode and

searching for your Bluetooth mobile device.

 Open the Bluetooth function on your device and search the

speaker named “TXBTDISKSPK”.

 After selecting this speaker, your device will pair without a

password. (If required, enter the password “0000” to finalize the

paring).The Blue light will begin to flash slowly after pair is complete.

 Start playing music on your device. Keep your device within 33feet (10 meters) of your speaker.

 Adjust the volume of your device to a comfortable level.

 Control play/pause, volume up/next track and volume down/previous track either on your connected device

or by the buttons on the fabric of the speaker.

 Turn off the unit when not in use.

PAGE 1
CQL1586-B Disco Ball Speaker Instruction Manual (Read before proceeding) FCC Statement: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
Light Operation    Push the Off●On button to the “On” position to turn on the unit, the light will light up automatically. Play music on your mobile device, the light will dance to the music. Turn off the unit, the light will turn off accordingly. Caution:     This is not a toy. Please keep away from small children. Please keep away from water / heat. Low power may cause poor connection even no working of Bluetooth. Do not over charge the battery.